
- 8 to 60 liters per minute (2 to 16 gpm)
- Pressure up to 100 bar (1200 psi)
- Ideal for machine tools up to 30 kw(40 hp)
- 900 and 1800 liter tank options let you create "mini" central systems

Automatically Variable Volume
This is the “gold standard” for high pressure coolant systems! It automatically pumps just enough volume to maintain full pressure.
Systems from other manufacturers pump a fixed rate that is most the times too much or too little, causing foam, heat, short filter life and short coolant life.
Multiple Pressure Option
Pressure options can be pre-programmed to provide filtered flood coolant in addition to preset pressures of 20, 35, 50 and 70 bar standard or any pressure up to 100 bar.
Standard configuration
The ChipBLASTER EV-60 is fed by a transfer pump (optional: CentraBLAST Pre-Filtration-Pump) that draws from the machine tool sump, through the filter vessel to the integral 480 liter (126 gal) tank. When the machine tool calls for coolant, the filter pump draws the coolant from the ChipBLASTER tank and pumps through the post (safety) filter to the inlet of the positive displacement pump. The coolant then flows at high pressure through a series of distribution and safety valves and on to the machine tool.
Machine Connection
ChipBLASTER systems are designed for using standard plug configurations. Our standard interface cables utilize these connections on both ChipBLASTER unit and machine tool sides. We are able to also supply female connector sockets for wiring on the customer’s machine tool side. In addition, we approve and supply customer specific interfaces, as required (with extra cost).
Potencia del motor [kW] | 7.5 |
Coolant Flow (Automatically variable flow) | 60 l/min. |
Pressure (manuel / set for safety) | 83 bar / 70 bar |
Coolant Outlet | 1 x Ø12.7mm, L = 4.5 m |
Feed Inlet | Ø25,0 mm, L = 4.5 m |
Filtration - Single Bag-Sytle filter, degree of purity 5µm (water) 10µm (oil) | |
post-filter (HP pump safeguard) | |
Integrated Tank "Clean Tank" | 480 l |
Tank Overflow Hose | Ø51,0 mm, L = 4.5 |
Transfer Pump - Standard transfer pump, w/ standpipe assembly | |
Interface - 1 x 12-pin Power Cable; 1 x 24-pin Control Interface | |
Error Signal dry contact for Machine Center (N.O. & N.C.) | |
MistBLASTER interface receptacle located on electrical enclosure | |
Dry contact provided for user supplied Transfer Pump control | |
Panel mounted gauges - Filter Inlet & Outlet + High Pressure | |
2 years warrenty | |


